The 15% FINE
15% Atomised FerroSilicon
Precision Separation, Peak Purity
Our 15% Fine FerroSilicon delivers an ultra-stable suspension with exceptionally low carryover and minimal media loss. It sharpens separation cut-points for finer feeds, boosting purity and recovery rates while safeguarding equipment and streamlining operations.
Enhancing Quality with FerroSilicon:
No Crushing, Only Atomisation: Precision-Engineered FeSi Production
By using water atomisation instead of crushing, our FerroSilicon forms ultra-fine, spherical particles with exact size control. This boosts separation efficiency, cuts equipment wear, and simplifies medium recovery—delivering consistent quality and peak plant performance. In practice, you benefit from consistent FeSi quality, fewer fines generation, and optimized plant performance—whether you’re processing scrap metal, coal, or mineral ores.
15% Fine Water-Atomised FerroSilicon
Our 15% Fine FerroSilicon is made with 14–16% silicon for corrosion resistance and strong magnetic response. Carbon is capped at 0.90% and iron is at least 82%, while aluminum and sulfur stay below 0.05%, phosphorus under 0.10%, manganese under 0.90%, copper under 0.50%, and chromium under 0.80%—ensuring a clean, dependable medium for dense-media separation 15-fine.
Particles are tightly graded so that 99–100% pass 315 µm, 92–98% pass 150 µm, 80–90% pass 100 µm, 60–75% pass 63 µm, and 45–63% pass 45 µm. This fine mix creates a stable suspension that sharply separates materials by density 15-fine.
With a true density of at least 6.95 t/m³ and a bulk density of 3.3–4.0 t/m³, it offers strong magnetic pull (≥ 65% Satmagan) and holds non-magnetics to ≤ 0.5%. A rust index under 0.2%, dynamic stability at 500–650 rpm, and a settling rate of just 1.4–2.7 cm/min deliver long-lasting, low-wear operation and easy medium recovery
15% Fine Water-Atomised FerroSilicon
Our 15% Fine FerroSilicon delivers ultra-stable, low-viscosity suspensions with exceptionally sharp density cut-points for fine feeds. Engineered with precise 14–16% silicon content and tightly controlled particle sizing, it maximizes separation purity and recovery while minimizing media losses and equipment wear.
For a complete breakdown of its chemical composition, physical properties, and performance advantages, you can download the full data sheet here.
15% Atomised FerroSilicon
MADE BY CLEAN NORWEGIAN WATER ENERGI!
Produced with 100% renewable Norwegian hydropower, our atomised FerroSilicon slashes CO₂ emissions and avoids volatile energy costs. You get a consistently high-quality medium, lower production expenses, and a reduced carbon footprint—helping you hit efficiency and sustainability targets in one go.